Blog Archive

Two Phase Musing: Part 3

This is the third post of a three-part blog on two-phase heat transport devices. It was supposed to be the final part, but if I get an inkling (and don’t retire first) perhaps I will continue with oscillating pipes or vapor chambers. If I do retire, it has been nice getting to know all of you over the years. (Editor’s note: We will not let her retire.)

Part 1: Thermosiphons: Pump not Included
Part 2: Heat Pipes: aka Magic Pipes

From beginning to advanced, here's your chance to learn how to use the powerful parametric and customization features in Thermal Desktop and SINDA/FLUINT. Click on each title to learn more, or to register.

Please note that earlier classes are prerequisites for later classes, so if you miss one, be sure to check out our recorded video page before attending the next one.

Symbols and Registers
Thursday Sept 26, 9-10am MT (8-9am PT, 11-noon ET)

Advanced Expressions
Thursday Sept 26, 2-3pm MT (1-2pm PT, 4-5pm ET)

Network Element Logic (NEL)
Tuesday Oct 1, 9-10am MT (8-9am PT, 11-noon ET)

Advanced Logic
Tuesday Oct 1, 2-3pm MT (1-2pm PT, 4-5pm ET)

flow regimes

Introduction to Two-phase Flow

September 24, 2-3pm MDT

This webinar introduces basic concepts in two-phase flow modeling including quality, void fraction, flow regimes, slip flow, pressure drops and accelerations, and heat transfer.

No knowledge of CRTech software is required. However, references to the corresponding FloCAD features will be made to assist users of that product.

Click here to register